How to layer gold-tone necklaces by length

Layering works when each chain has its own place on the neck. The simplest rule: leave about 5 cm (2 in) between lengths, so the chains sit apart instead of tangling into one line.

1. Start with the shortest chain

Put the shortest piece on first. A 40–42 cm chain sits at the collarbone and gives the stack a clean top line. The Simulated Pearl Drop Necklace is about 40 cm with a 6 cm extender, so it can be the top layer or the middle one.

2. Add a middle length

A 45 cm chain sits just below the collarbone. The Sphere Necklace is 45 cm, and the Herringbone Necklace comes in 45 or 50 cm.

3. Finish with a longer chain

A 55–60 cm chain lands on the upper chest, over a crew neck. The Torild Mariner Link Necklace is 55 cm and the Jofrid Mariner Link Necklace is 60 cm.

Mix textures, keep one finish

Pair a fine chain with a heavier link, or a plain chain with one pendant. Keep the finish the same, all gold-tone, so the stack reads as one look. Two or three chains are plenty for most necklines.

Keep them from tangling

Fasten each chain on its own and turn the clasps to the back. When you take them off, store each piece in its own pouch.

Not sure which length suits you? The size guide shows where each length usually sits.